C
Latest activity Postings Media About
-
-
CChrisLPC reacted to kupus007's post in the thread Hayward gas heater only works in manual mode with
Like.
That was it setting it the pool while in BO! Its always the simple things. Thanks! -
CChrisLPC replied to the thread Hayward gas heater only works in manual mode.check for a comm wire either on LV1-LV4. Make sure the heater displays BO when operating from the Omni. Under config menu from the Omni...
-
CChrisLPC replied to the thread Hayward OmniPL "MSP_DEV_COMM_LOSS,Comm Loss Device:01-41-11-23-fe HUA:MP" error.Go into service mode and look around. There should be rollback or back up files. Then try to update again after rolling back.
-
CChrisLPC replied to the thread Hayward OmniPL "MSP_DEV_COMM_LOSS,Comm Loss Device:01-41-11-23-fe HUA:MP" error.When they installed how did they get your system up to date with the current 4.8 firmware. If it was not 4.1 or above they would have to...
-
CChrisLPC replied to the thread Bypass Hayward Aqua Plus.
-
CChrisLPC replied to the thread Bypass Hayward Aqua Plus.If you have all Hayward equipment and want automation for it I would suggest the Aquarite S3 Omni. It has capabilities to control your...
-
CChrisLPC replied to the thread Bonding fiberglass pool with an autocover..Thank you. Spent late last night sifting through the forum and got some really good info. Make sure split bolts you use are for direct...
-
-
CChrisLPC reacted to ajw22's post in the thread Bonding fiberglass pool with an autocover. with Like.
See if this thread helps you... https://www.troublefreepool.com/threads/autocover-bonding.131707/ I would think the tracks, brackets...
-
CDoes anyone have experience with bonding autocovers? Types of lay in or mechanical lugs used to bond the autocover tracks and brackets...
-
CChrisLPC replied to the thread Dry fitting PVC. What's the trick?.I loosely dry fit. Measure the pvc from elbow to elbow or coupling then add the depth of the full fit to the pvc. Most schedule 40...
-
CI’d like to learn too. I gave up on that a while ago and now just measure the socket depths and cut all the pipe on a miter saw to keep...
-
CChrisLPC replied to the thread Omni Logic and Pal lights?.I did find this. It’s showing that you don’t have to ground the driver???
-
-
CAlmost done wrapping up an install. It says on the Pal light driver that it is compatible with Hayward automation. Just put the dip...
-
-
Loading…
-
Loading…
-
Loading…
