ChrisLPC's latest activity
-
CChrisLPC replied to the thread Replace aging TCELL940 with TCELLS340 ?.Omni PL’s will give you the option to choose the exact cell. It should say 940 or 340. Make sure to have the cell unplugged before...
-
CChrisLPC replied to the thread Deck jet plumbing help.10 deck jets is a ton! Even doing loops would make it hard to have all 10 decks jets look the same. I installed valves at the pad...
-
CChrisLPC replied to the thread New pool Plumbing diameter.I think the 950 wouldn’t be sufficient to have everything running at once. I would upgrade to a HCP 3000. It has 3” inlet and outlet...
-
CChrisLPC replied to the thread Hayward Laminar Installed Without Equalizing Loop.Hayward Laminars come with little orange valves. You can adjust them individually. They also have screens in the other side of the...
-
CChrisLPC reacted to 1poolman1's post in the thread Water Feature, separate pump? Need advice! with
Like.
This is not a DIY project if there is no dedicated suction line to supply the extra pump. You do not want two pumps pulling from the... -
CChrisLPC replied to the thread Water Feature, separate pump? Need advice!.Yes get a separate pump. The only time I have not used a separate pump on builds was just a pool and deck jets. We still upgraded to a...
-
CChrisLPC reacted to BMerrill's post in the thread Hayward Laminar Installed Without Equalizing Loop with Like.
Typically laminars are not piped on a loop but utilize individual valves to each laminar allowing flow adjusts for water arch height...
-
CChrisLPC replied to the thread Globrite Stuck.I have found that during installation some crews do the horrible act of running the wire through unglued conduit pieces and then glue...
-
CChrisLPC replied to the thread Hayward Color Logic/omni PL issue.Reconfigure the lights making sure to enable Omni direct mode if they are color logic 320. Make sure to select the correct light when...
-
CChrisLPC replied to the thread Aquarite S3 not communicating with pump.Very important to turn power to the pump off after setting the dip switches for 10-15 minutes. It resets the pump.
-
CChrisLPC replied to the thread Aquarite S3 not communicating with pump.The comm wire you ran needs the connector in that plastic bag then switch it out with the one already attached. You can just tuck it in...
-
-
CChrisLPC replied to the thread Aquarite S3 not communicating with pump.The dip switch in your pump is light blue in color
-
CChrisLPC replied to the thread Aquarite S3 not communicating with pump.The number 1 dip switch is still up. All dip switches need to be off. Also once you apply power to it with the dip switches set there’s...
-
-
CDoes the Omni PL have this capability? I have a customer asking me about it and I thought it does. I know it sends email alerts. I have...
-
CChrisLPC replied to the thread PAL Low Voltage Pool light.Pal lights usually come with their own driver and a remote. At least the ones I have installed do.
