Hello, I currently upgraded my Hayward ProLogic to OmniPL.
I noticed the new OmniPL board does not have a direct connection for the black/white wire like the older ProLogic had.
I read I’m supposed to wire the black/white wires to a new relay, which we did, exactly as the instructions stated. When I “test” the relay on “Service Mode” the relay kicks on and the PH Disoenser pump begins to dispense Acid.
However, when I go to “Add” the “Chemistry Sense Module” the system can not find it… it’s blank.
I connected the sense & dispense probes to the “LS BUS” connection on top of the new OmniPL board just like the instructions say. But the system still can not find it. I tried all 3 LS BUS connections and nothing, it’s not getting any power.
Anybody know how to troubleshoot this?
I’ll add pictures of the installation and circle the old board connections with the new board without the connections.
Thanks
Picture #1: Old board showing PH Dispenser specific connectors
Picture #2/3: New board where PH Dispenser is connected to
Picture #4: Breaker/Relay wiring.
Picture #5: Old board
Picture #6: New board
I noticed the new OmniPL board does not have a direct connection for the black/white wire like the older ProLogic had.
I read I’m supposed to wire the black/white wires to a new relay, which we did, exactly as the instructions stated. When I “test” the relay on “Service Mode” the relay kicks on and the PH Disoenser pump begins to dispense Acid.
However, when I go to “Add” the “Chemistry Sense Module” the system can not find it… it’s blank.
I connected the sense & dispense probes to the “LS BUS” connection on top of the new OmniPL board just like the instructions say. But the system still can not find it. I tried all 3 LS BUS connections and nothing, it’s not getting any power.
Anybody know how to troubleshoot this?
I’ll add pictures of the installation and circle the old board connections with the new board without the connections.
Thanks
Picture #1: Old board showing PH Dispenser specific connectors
Picture #2/3: New board where PH Dispenser is connected to
Picture #4: Breaker/Relay wiring.
Picture #5: Old board
Picture #6: New board