Jandy AquaLink RS one touch control system

[edima302]

Hi everyone,
Hoping to get some help with my one touch Jandy Aqualink control system. We opened the pool but the indoor controller does not work so I have the pool running on service mode.
The LCD screen is blank and the only thing I am getting is an amber (red/yellow) light at the bottom right of the panel that is normally either green or red when the heater is on.
The unit is about 4 years old and shouldn't go bad on me yet so don't know what it is. I plan on looking at the outdoor control panel to see if perhaps a wire is loose but crossing my fingers.. any help will be greatly appreciated.

 

[ajw22]

@PoolGate has the One Touch controller.

 

[PoolGate]

Check the controller side first. It is also possible you just need a full system reboot (power cycle).

 

[PoolGate]

I just made a short video for the OneTouch.

 

[Rossterman]

At some point you may want to consider upgrading to iaqualink. It was ~ $600 to diy and now everything runs off phone or ipad. No more need for those slow, bulky controllers.

 

[edima302]

I just made a short video for the OneTouch.

I just made a short video for the OneTouch.

I opened up the control box outside and found a loose wire so problem solved! Thanks for the help and video.