Latest activity Postings Media About
-
-
I get into battles with wasps/bees and from 50+ft away, the HO can't see them and I prolly look like somebody high on bath salts... -
Lake Placid replied to the thread What did you do to your pool today?.There was a high speed maneuver as I was diving over the coping with my left hand to grab it. I hit it twice, then the slow motion set...
-
Only I didn't say fudge. I said THE word, the big one, the queen-mother of dirty words, the "F-dash-dash-dash" word
-
I envision a slow motion panic as the bar flipped though the air like General Zods phantom zone prison in Superman 2...
-
Lake Placid replied to the thread What did you do to your pool today?.I could barely make out the bar yesterday but couldn’t get it with the vacuum before I stirred debris into solution. I’m guessing 4...
-
Lake Placid replied to the thread What did you do to your pool today?.I dropped my stir bar in the deep end of a new clients algae addled swamp. I cussed, then cried, then ordered 6 more from Amazon. Then...
-
Lake Placid reacted to BsPool's post in the thread *Rubber Expansion Plugs Stuck in Jets... Need Some Help! with
Like.
I got them out! I had to spin the wing-nuts as far as they would go without falling off. From there it just took a little finesse/wiggle... -
Lake Placid replied to the thread *Rubber Expansion Plugs Stuck in Jets... Need Some Help!.Before you fully remove the wing nut, loosen it to the last thread or two. Then knock the bolt forward - you won’t risk losing it in the...
-
Lake Placid replied to the thread Vaccuum Port Cover.I can’t find any dimensions in a quick search for the outer diameter of the cover, but you may be able to create a “skirt” that will fit...
-
Lake Placid replied to the thread Step-by-Step Guide.After re-looking at the picture, I’m not thrilled with the orientation. The valve is partially closed to all ports. Now that might be...
-
Yes. Those ball valves are junk and will eventually fail. There are unions, so you can disconnect and build a new suction manifold...
-
Lake Placid replied to the thread Step-by-Step Guide.If they were stored dry they are likely trash and you’ll need new ones. The should always be stored in the caps with distilled water at...
-
Lake Placid replied to the thread Best way to bypass heater.If your pump supplies over 80 gpm an external bypass is recommended, and the flow to the heater when setting the bypass should be a...
-
Lake Placid replied to the thread Step-by-Step Guide.Yes remove the gizmos from the skimmer - install the baskets and remove the plugs from your return outlets. Install the return jets. I...
-
I just picked this up from Home Depot.
-
-
Loading…
-
Loading…
-
Loading…