The internal latch system appears to have become and not allowing me to lift the knob to open gate. Any suggestions of how to gain access and fixing please
Magna Latch pool gate closer
- Thread starter Keithsimmo
- Start date
- Jul 21, 2013
- 64,776
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
I don’t think there is anything serviceable in the latch. Just remove the screws and replace it with a new one.
I don’t think there is anything serviceable in the latch. Just remove the screws and replace it with a new one.
Thank you very much. Unfortunately I am unable to open the gate to remove the screws. If the problem is unable to be fixed, perhaps I should hacksaw the lock and buy a new one
- Jul 21, 2013
- 64,776
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
There are videos on YouTube of how the latch installs to see where the screws are.
Can you remove screws on the gate hinges to open it?
Can you remove screws on the gate hinges to open it?
All fixed. I was able to push down on gate which gave me access to the plunger being held down by the magnet. I prised this up with a screwdriver which allowed the gate to open.
removing and opening the mechanism I found a spring and the plunger which had become unclipped. With a little difficulty I managed to re clip the plunger and spring. Attached to gate and presto.
Everything is working well again.
Cheers everyone and thank you for your time.
removing and opening the mechanism I found a spring and the plunger which had become unclipped. With a little difficulty I managed to re clip the plunger and spring. Attached to gate and presto.
Everything is working well again.
Cheers everyone and thank you for your time.
- Jul 21, 2013
- 64,776
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
