Jandy salt cell not working. Should I replace everything?

Jump to latest Follow Reply
E

emil

0
Oct 21, 2014
117
Tujunga, CA
Hi everyone,

I have a saltwater pool, almost 7 years old. The salt cell is leaking and not working. I've been trying to "google" it. Do I need to replace the whole thing or can I just replace the cell? Can I replace it myself or is it better left up to the poolman? Has anyone done this before, is it easy? I was reading something about the new connections being square vs the existing circular connections? The reviews don't seem to be good, do I need to use this exact one?

Jandy AquaPure PureLink 3-Port 14-Blade Replacement Salt Cell Kit | 40,000 Gallons | PLC1400
Amazon.com : Jandy Zodiac AquaPure PLC1400 PLC 1400 Saltwater Cell Kit AQUA PURE : Swimming Pool Timers : Patio, Lawn & Garden






Model: Jandy PLC1400
Any tips/comments appreciated.
 
Easy to replace if a simple swap. Let's ask @PoolGate

Be ware there will be no warranty if purchased via Amazon and not an authorized Jandy dealer with install.
 
It's very simple to replace yourself the cell is a consumable and designed to be owner replaced. I was not aware of any differences in newer cells. I would just get one and replace it. It'll come with everything you need to install it best case you unscrew one and screw in the other. Worst case there is some minor plumbing to do you can call any plumber for that.
 
PoolGate said:
It's very simple to replace yourself the cell is a consumable and designed to be owner replaced. I was not aware of any differences in newer cells. I would just get one and replace it. It'll come with everything you need to install it best case you unscrew one and screw in the other. Worst case there is some minor plumbing to do you can call any plumber for that.
Click to expand...
Thanks for the help.
Is the link from the pool supply the correct one?
Is it literally plug and play? Do I need to adjust anything via the aqualink app?
 

Replace the Power Cord When you Replace the Cell​

When replacing the cell, it's important to replace the power cord so that the connections are clean and the resistance is minimized.

The prongs are sealed by O-rings and a compression plate held down by two screws. The problem is that the O-rings can leak, which creates a corrosive mix of water, salt, hydrogen gas and chlorine gas. This corrosion increases the resistance of the connection and generates a lot of heat due to the high current of 6 to 8 amps.

The center prong is the most common point of failure. You can usually see evidence of a leak when you know to look for it.
 
Remove that large connector from the cell and take/post a pic of where it plugs into the cell. Usually you can see if the corrosion is present. Post a pic of the cell side of the plug when it's off too.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply