Heater/Goldline Aqualogic and more
- Thread starter Gingermom
- Start date
Thanks - I think this is it - may not be the only problem - but it's where I will start. I can't get it out of bo and no other error code comes up. the light being out and showing ho threw me. Thanks for your help and all the links. Now to find the part.
In your picture, it is in "bo" and Standby.
It needs to be in bo and in Pool or Spa mode.
It needs to be in bo and in Pool or Spa mode.
My recollection is that before hitting the mode key cycled through pool, spa and standby, but nothing I do seems to change it.
Replace at least the keypad so you can change to Pool Mode or Spa Mode.
Old style FDXLBKP1930 Bezel & Keypad Assembly (No Display Board).
FDXLBCP1400. New Kit-Bezel Control Panel, 400. Bezel, Display and Keypad plus an adaptor.
FDXLBCP1400. New Kit-Bezel Control Panel, 400. Bezel, Display and Keypad plus an adaptor.
Last edited:
Hayward FDXLBKP1930 Bezel & Keypad Assembly, Universal H-Series Low Nox Heater - INYOPools.com
BEZEL & KEYPAD ASSEMBLY UHSLN (FDXLBKP1930) - Pool & Spa Parts
www.inyopools.com
___________________________________________________________________________________________________________________
___________________________________________________________________________________________________________________
The keypad sits over the display board.
The clear window sits over the display board LED.
The 4 pin connector connects the keypad to the display board.
The 4 pin should be a common and then one wire for Up, Down and Mode.
You can trace the wires to see which trace goes to the Up Button, Down Button and Mode Button.
Closing the common to the pin makes the function happen.
For example, closing common to up makes it go up.
Peel off the membrane pad and show the back.
Put waterproof tape over the opening.
Shut off power to the heater until you can replace the keypad and bezel.
Generic Chinese Keypad, Bezel and Display.
My guess is 1 is common and 2, 3 and 4 are Up, Down and Mode, but you can verify.
The traces will be something like this.
A trace will go from a pin to a button.
Each button will also go to common.
The clear window sits over the display board LED.
The 4 pin connector connects the keypad to the display board.
The 4 pin should be a common and then one wire for Up, Down and Mode.
You can trace the wires to see which trace goes to the Up Button, Down Button and Mode Button.
Closing the common to the pin makes the function happen.
For example, closing common to up makes it go up.
Peel off the membrane pad and show the back.
Put waterproof tape over the opening.
Shut off power to the heater until you can replace the keypad and bezel.
Generic Chinese Keypad, Bezel and Display.
Loading…
www.amazon.com
My guess is 1 is common and 2, 3 and 4 are Up, Down and Mode, but you can verify.
The traces will be something like this.
A trace will go from a pin to a button.
Each button will also go to common.
Last edited:
Sorry need to also replace the board that comes later today before posing my question.
Last edited: