Cantilever coping with foam forms over vinyl

[michellegerman]

My PB Followed written instructions in regards to steps, so we now have water just below the inlets. Looking ahead, we are supposed to pour the deck. This is where the problem comes in. We have cantilever coping holding the vinyl liner, and two boxes of Mortex foam forms and the clips.

i just can’t see any way to adhere the forms to the vinyl lining and poking the clips into the track without permanently damaging the liner.

How in the world are we supposed to securely attach the foam forms and pour concrete at this point?

 

[broschb]

If I'm remembering correctly you are referring to the plastic pins you push through the form and into the liner track, correct? I would think that would damage the liner.

Are you doing the build or do you have a builder? If builder I would hope they have done this before and can explain how they are doing this.

Mortex also has some pins you can use to hikd the forms in place. You can see an image here.

https://encrypted-tbn0.gstatic.com/...uwOFSK9S-xqoUzEyUmvUUn-wNCErTemxhqZOfbYMvVvO

Mortex sent me some for my build, give them a call they were super helpful.