Good morning. I have a Sale Cell Inspect Light on. I inspected and cleaned it. It says to Push "+" to rest. That doesn't seem to reset it and it is still flashing. This is an older Hayward Goldline system.
Salt Cell reset not resetting
- Thread starter wille
- Start date
- May 3, 2007
- 17,207
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
If you toggle through all the normal messages using the right arrow, is there any other error message?
Also, are you doing this on a remote or the local display?
Also, are you doing this on a remote or the local display?
Similar threads
