Hi everyone - Been going through all the various threads and am just not knowledgeable enough to know if this has been answered somewhere so apologies if it was. I have a mess of pool equipment and upgraded my panel to OmniPL from a (very) old Goldline controller. I have most of the Hayward Omni programming completed successfully, but there are a few items I cannot figure out how to complete.
1) Raypak Heater control - This is connected via 2-wire to the LVL1 connectors on the OmniPL board as per the instructions. The heater power is connected via the Filter (HVL1 in my system) relay and not directly to the breaker. Note - I recently installed a Hayward 2.4hp VSP which is directly connected to the same breaker. I cannot get the system to reliably turn on the heater to heat no matter what I do (via app or control panel). It has turned on randomly but I cannot consistently determine how. Any insights on if I have something configured or hooked up incorrectly?
2) I have a pool and spa. I have a valve that the old system would automatically activate when I switched between pool and spa modes since they are both plumbed to the main filter. However, I cannot figure out how to get that valve to activate when I enable the spa filter in the Omni system. I do not see the appropriate option.
I am including a picture of the equipment and panel for reference and have highlighted the valve and heater wires. Thank you in advance for the help and long live TFP!
1) Raypak Heater control - This is connected via 2-wire to the LVL1 connectors on the OmniPL board as per the instructions. The heater power is connected via the Filter (HVL1 in my system) relay and not directly to the breaker. Note - I recently installed a Hayward 2.4hp VSP which is directly connected to the same breaker. I cannot get the system to reliably turn on the heater to heat no matter what I do (via app or control panel). It has turned on randomly but I cannot consistently determine how. Any insights on if I have something configured or hooked up incorrectly?
2) I have a pool and spa. I have a valve that the old system would automatically activate when I switched between pool and spa modes since they are both plumbed to the main filter. However, I cannot figure out how to get that valve to activate when I enable the spa filter in the Omni system. I do not see the appropriate option.
I am including a picture of the equipment and panel for reference and have highlighted the valve and heater wires. Thank you in advance for the help and long live TFP!