Search results

Yikes! I ordered that. And yesterday I had shut the gas off and the side panel power switch is off and its not currently wored to the aqualink. This was a rental that I've recently moved back in to. Sounds like I'm fortunate nothing bad happened.

You aren't kidding about multiple issues lol. Well, I did what you said and tried to ground the wire during clicking. It sparked and shut off. Which made me investigate a short somewhere further. I unscrewed the left side panel and found this fuckery. I'm assuming this sensor is bad and someone...

I feel The wiring appears to be intact. I definitely hear that click of the valve. I’m pretty sure I heard the pilot light as well. The igniter continues to click. Is this what you mean? Does that still sound like an internal short of the valve?

Yes it lights up with every wire except the ground. Once ground is connected it doesn't work. With the ground disconnected, the board will read SPRK and I hear continuous "ticking" from ignitor. I noticed the actual heater doesn't appear ground/bonded, so when I ran copper wiring from the...

why will the board only turn on when this harness is disconnected? The wiring appears to go to the gas valve.

Excitement followed by more frustration! To recap, I’ve moved back into this house after being away for 8 years. So I’m learning all this equipment again. My previous pool guy said it was the board so when I moved in I bought a used but tested board and it didn’t work. Thinking it could be the...

Noted.

Well the new board came and I’m still getting the same result, no power. Not sure what it can be. Any other ideas Poolman?

Ok, so the yellow one has continuity and the red one does not. The red fuse physically resembles the one you linked the most. Man it's hard to find this level of info out there on the interwebs. Even searching by that fuse I couldn't find much. I had already ordered a new (used tested good)...

Transformer is new, and verified 24v out.

Is that fuse one of the ones I circled in red?

Thanks for the response! Where is that located on the board and can I check the continuity with my multimeter?

I need help. I can't seem to get a power response from the heater. The digital board won't light up. As the pics show I'm getting 27v to the board. The board is brand new. Is there any other reason the display won't light up other than the board? Or any other testing I can do to diagnose? I did...

Perfect, thanks. 2 speeds is all I want.

No IAQUALINK. It looks to be a RS6.

I'm not sure. Is there somewhere on the panel I can find that?

Thanks a lot for this. Here's more pics of my relays.

This is my panel