Recent content by easyliftn

49 F degrees this morning and SWG quit working. Fair amount of rain yesterday with nightly temps in 30's is really putting a damper on water temp and more so on my mood haha. Just want to swim, been open since mid April. Hopefully the weather warms up soon.

My inground is 32 x 16 vinyl with the corner stairs as well. Got the S200 and it kept climbing the steps to the top one and get hung up in the corner. So I returned and went to the Active 30i. Main reasoning was the floor only option. Notice the same behavior with backing up to the wall and...

So newly installed Circupool RJ45+, water clear and balanced, and salt tested at 3400 ppm. Really excited to energize and use it but my water temp is holding at a balmy 55F. Is it best to hold off until the water gets into the 60s? And thanks again to this forum for a great opening using TFP...

Didn't check water temp, but water is cloudy when I peeled cover back to take a look. Planning to open this weekend or next. No intent to swim just want to get the water right. Did test water and reading 0 chlorine left from closing, PH at 7.2.

Or the flow switch. I can install that after the swg with this model. I believe it states the swg can serve as the straight pipe distance requirement.

It's a circupool rf45+. I wonder if the 3' for the intellifo is needed cause the control panel is integrated on the swg and is heat sensitive?

Is there any restriction with installing a swg on the elbow directly out of the heater return? Have just enough length to install swg but its close. Thanks

thanks for the info, i assumed a similar set up

Texas, thanks and great write up. I was lazy and purchased the same kit MacGyver. Although I am still leaning to buying a new union kit for the pentair heater, replacing the DWV elbow set out of the heater return to raise the elevation of the pipe so I can invert the SWG cell, and run it...

So I researched the fittings and read the post in the link. I can honestly say you learn something new everyday. Since I have no leaks, I will leave them alone and better educated to repair in the future. Thanks for that, lol. So option 1 using vertical installation? I do like the idea of...

The installation was completed by pool installation contractor years ago. The part number on the elbows are 411-9130 sch 40

Hello, First, I would like to thank everyone on this forum for the education, advice, and guidance in properly maintaining my inground pool. Great resource with great people on this forum. With that being said, I have decided to install a SWG on my 17K gal inground vinyl pool with VS pump...

I have used the Pool Blaster Max for almost two years. Good suction and also using the silt bag which appears to capture the fine debris pretty well. For those of with vinyl, did you leave the wheels on the vacuum head? Im probably too over cautious when I think about it. But I stayed away from...