Identify multiport valve

[Jenrmead]

Once again it's spring and I'm having trouble starting my pool. I had taken the motor off of the pump
housing to unjam the impeller, then replaced
the gasket there when I was getting air in the line. Now I can't get the system to prime. In trying to diagnose the problem I put it on recirculate and saw water coming out the waste port. From other posts I think I may need to replace the multiport spider gasket and/or the handle spring. I'm having trouble identifying the model though-assistance please?

 

[kimkats]

Jen, I found quite a few that looked close to that one but don't know which one it is for sure. Do you have any idea of the model?

I bet if you talked to Swimming Pool Supplies - Pool Parts - INYOPools.com they could figure it out for you. I did find a gasket that says it is for quite a few of them but am not sure if it is for yours.

Kim

 

[satpoolman]

Look for the model # on the filter, then from that you can track down the correct valve info.

Regards,
E

 

[Jenrmead]

Look for the model # on the filter, then from that you can track down the correct valve info.

Regards,
E

* the sticker has a place for the model number but it's blank-I'm guessing that type was worn off over the years.

 

[Bama Rambler]

That is a SP0710XR50 1½" valve for a ProGrid or MicroClear DE Filter.

 

[satpoolman]

That is a SP0710XR50 1½" valve for a ProGrid or MicroClear DE Filter.