Search results

That certainly explains the seemingly sudden bearing noise. Thanks for the information. Looks like I know what I'm doing this weekend...

I've got quite the story and am looking for troubleshooting direction. For starters, I didn't realize how unlikely it is for me to have absolutely ZERO issues with my Ecostart pump since June 2013 until this year. Maybe it has to do with the fact that I completely disconnect the pump and store...

dradam - would you be willing to print & sell me some sliders? i use the PCS 22727

Any more suggestions on my next steps?

hopefully blue pool with brown stains and not the reverse... sure hope it isn't just a big toilet bowl

So I'm back to leaning towards copper.... based on this thread... Ascorbic Acid staining plaster black thoughts?

And the ascorbic acid turned the surface a dark brown where I tested. See attached picture.

I jut got back from Leslie's pool and the water tested negative for copper and iron. They used test strips. I also tried ascorbic acid spot test with no stain removal.

Thanks, I will try that out Dean. In the interim, I found out the previous owners did indeed have a heat pump installed at some point prior but removed sometime recently. I found this out b.c I made a comment to my father-in-law that it kind of look like a copper roof oxidizing. That thought...

I am helping my in-laws who purchased a house in Ft. Myers, FL. The pool was built with the house around 2005. There are either blotchy stains all over the pool or the entire surface is discolored as I don't know what the original intended surface color. I have attached pictures for you all...

I have been having issues with my Hayward Prologic. The Orp has been unable to keep up the sanitation. Initially I believed my issue was either a bad cell or bad sensor. Today, I checked out the equipment pad and my CO2 injector line was frosted over. It looked the same as a frozen HVAC...

Found the answer for anybody having this issue in the future. Follow the steps below. Regular text is what was provided in manual Red text are my edits. To control the board using an external switch, follow these steps : • Turn on the heat pump. • Set POOL mode to OFF. • Set SPA mode to the...

Thanks for the warm welcome and speedy reply. I've been reading for a few months, but this is the first time I haven't been able to find an answer to a question without a new post. The instructions I included in the original post were copied straight from the HeatPro Installation manual...

I'm trying to hook up my heater which is the Hayward HeatPro HP21404T to be controlled by the hayward prologic (pl-p-4). The Hayward manual... it says: To control the board using an external switch, follow these steps : • Turn on the heat pump. • Set POOL mode to OFF. • Set SPA mode to the...