Search results

Thanks! Worked out perfectly

pigtail that as well?

I should be able to wire nut the the black from the light and the swg together with pigtail into CB, The white into the neutral bar and green into the ground bar. All within the Circuit Panel

Thank you I will disconnect the pool light from the relay and just wire that to a switch and the dedicated 20amp 120 breaker The SWG will just use the 2 relay wires to connect the black from the SWG to relay to breaker. I am thinking of using the same 120v 20amp breaker that the pool light uses...

I have everything installed on this RJ45+ except wiring. This SWG will be wired through my Intelliflo3 pump relay board. The left relay is my pool light 120v and the right is my 220v Spa Blower. I am going to have to use the two wires from the pool light for this config. Will I have to config...

Thanks for the replies. I ordered the RJ45 and I can wire it to one of my Intelliflo relays. One other question.. is it suggested to get a sacrificial anode such as a Pool Tool 104-D 104D

How many amps does the rj45 plus use at 220v? I could probably connect it to my pump circuit if its low. I have 100 amp service at the pool and all slots are filled. Both the pump (20 amp) and heater (60 amp) are on 220

I have an 18.5 k pool that I had redone last summer. My initial thoughts are a CircuPool® RJ-30 PLUS. Would this be the correct decision? I have no automation other than what my 24/7 pump provides The mechanicals were done by me so I left a spot for an SWG, just after the heater bypass. I...

My pool was plastered with Luna Quartz Pacific at the beginning of June. This is what my pool looked like. The PB came out and said this will clear up and I will love it. IF not they would do a Hot Start at the end of August to clear it up. No worries! They just finished the Hot Start with...

Silencer

The reason i am asking is the Manual doesn't specify breaker size. http://www.airsupplyflorida.com/wp-content/uploads/2014/08/installation-guide.pdf WIth this blower only rated at 3.5 amp I am assuming 20 amp is overkill. Maybe 15amp?

I just purchased a Air Supply 1HP, 240v, 3.5 amp blower. Can I be safe to assume a double pole 20 amp breaker, #10 wiring, and #8 bond wire be sufficient?

So using this chart I have a 5 jets with 5/16 inch nozzles My GPM should be about 12GPM. So I should run my pump at 48GPM?

I have 4 jets in my small spa connected to my pool. They seem to be Pentair Mixing Nozzles that are screwed in my spa ports. Would anyone know what the GPM for these jets are? Are there better replacements to use? Pentair Venturi Jet Extension, Diversion Gun Vent Jet Mix Nozzle, White, 46543000

Just finished pool reno 1 1/2 weeks ago. I am noticing a few issues and am seeking advice before I confront PB. Can they be fixed. Blotches, some pretty serious looking Quartz finish halfway up all 1st level tile grout joints. Some top tiles have splattering. After telling PB that some...