Search results

I have the same pool. My pump seemed to be really loosing output after a few days and I can tell since the PSI goes up quite a bit. Couldn't really figure it out since backwashing didn't discharge much dirty water at all, and PSI would go back up shortly after. I took the top assembly off the...

Pool is filled. Really happy with how level it is. Too cold for me, but kids went in today and had a good time. The U-shape legs never really moved out much at all. I’m barely on the paver blocks on one side. A couple U-shape legs on the other side are not on the pavers at all. Just put some...

I laid out the foam insulation yesterday and put up the frame. After putting up the frame, I’m concerned the pavers ‘under’ my U-shaped legs are too wide. Right now it is difficult to put both sides even on the very closest edge. They are 14 feet on center, which should be good according to the...

Progress update. After a rainy week here in Iowa, the mud dried out enough to put some pavers in. I made the mistake of starting at the highest point and sinking paver in until it was 1/2” out of the ground (for 1/2” foam). By the time I got to the lowest point the paver didn’t need dig in at...

Hi everyone, We purchased a 12'x22'x48" Bestway pool from Costco. I've had some work done on trying to level the spot. It is going along the side of our house since that is the most level area that doesn't get a small stream flowing through it during a hard rain. Red outline was the original...

I have this same pool sitting in the box waiting to put up after ground prep. There is a picture at the bottom of the box that gives dimensions. The specs give 14 feet 2 inches for the width of U shape supports. 11 feet 3 inches for the top frame. So I think they will be out 17.5 inches from the...