Recent content by william13

I think I may have found my fountain My only remaining question is this. Can these be put in as a replacement without significant damage to my pool (by a professional)...

In this situation. The outside of the port pipe was the same diameter as inside the 2 inch coupling. The inside of the port pipe is the same as the 1.5 inch pipe that went to coupling. So the question is: Is there a pipe that fits into 1.5 inch pipe? I think the mesh is to disburse water...

Ordinarily at this point I would order a new part but things seem to be out of stock and no I wonder if I can even replace 2 of them (48 inch ARC Cascade Waterfall is what I have been googling with rear port) . Wondering if this could be cemented over port facing in or out. Would the right...

Thats interesting!

Well it went fine technically. The molded pipe did break off and not much space to insert anything. I would say we are going from search and rescue to "recovery" Appreciated everything so far. I would love ideas what to put in place. I have two of these side by side and unless I can find...

Cut and can not turn. Must be glued and not threaded or glued and threaded.

Yes, I used the word lip incorrectly I guess. So I have a 1.5 inch pipe inserted into the round molded 2 inch pipe and its the molded pipe thats cracked. I will cut at this point. Thank you everyone for input and especially your patience.

yes I am on the same page but if I am using a 2 inch coupler over a male junction the crack is in the male junction right and not repairable right?