Recent content by SamsIam

I am replacing my easytouch module on my controller due to continual failures. Can you run node JS over non RS-485? I have my intellitouch wired into my network. My rs-485 cable I had run previously got destroyed by my lawn guy and I never fixed it. Need to back up my config.

replaced wire, same thing.

OK, I did replace this one and no change. Is that the right one? When I enable the heater I do hear a relay (before and after replacing it) When I turn heat on at the pool level nothing happens - heat setting cranked up to 90. Don't see LED on panel turn on for Heat.

my guess is its why my pool/spa keeps flipping as well (something on the controller). it will just randomly switch from spa to pool. i have to get back to looking at that. i have an overflow so i just let it run that way for now.

yea that is what i was worried about. @ogdento helped me and repaired my board. from recollection, i had some funky issues on the heater sometime after. thanks and glad it is socketed. i may even have one already. i think i may have replaced one other. appreciate the help!

ok, i jumped it and it fired up so EasyTouch panel i assume. i did check the wiring from the heater pins but i will double check them.

thanks! will give that a try in the morning.

So with the temps dipping into the low 90s in Texas it is time to get my heater going ;). And it won't fire. I have it wired as it has always been, turn heater on in features, then activate in pool or spa (in the app) and set temp. Pump runs up to speed as it is set to do but Heater never...

with some help from Jim and others I cannot be happier with my new pump! so much quieter than the old on too. got it at polytech. great price as well

Thanks, I will look and respond to these questions later today. Not sure I will be able to or not until late. Got a few things going on. @Jimrahbe sure hope you are ok in Bedford. I heard you had the baseball size hail in that area and then you got the high winds. Crazy they were up to...

no sir. i have never used that

question, for a ~17k pool is an ic40 enough or should i go with the ic60?

as i suspected because i have done this before. all leslies, one pinch a penny, and some random place. gonna try the random place because i already submitted requests to leslies (who charges a 60 dollar fee for service call plus a 45 gas fee) and pinch a penny did not respond.

This one is an odd one for sure. @Jimrahbe @ogdento - calling you up since you are good resources and somewhat familiar with my plights. last week i replaced my temp sensor for the pool and after that i have experienced an odd phenomenon i cannot figure out. i think it may be coincidence on...

i had a feeling that was gonna be a suggestion. thanks