Recent content by Parac

What is your CYA? And what FC are you typically aiming for? Any chance the party dropped your FC low enough and you have algae starting that the SWG just can't keep up with?. Do an Overnight Chlorine Loss Test to rule out algae.

The stickied TFPC for beginners post is one place that only mentions household bleach.

I left it in place on mine. Kinda seemed like it was supposed to be there, but I don't know exactly what it does. Possibly something with stability and keeping it upright.

You can squeeze the sock and work it out after it has been soaking for 30-60 minutes. No need to wait days for it to fully dissolve on its own.

@EliaZinn Can you confirm you have revision Y? Can find it in the web interface in the "help" section I ask because this thread started with replacing a PLC1400 cell which would generally mean your pool is more than a few years old. In the Wiki revision Y has an unknown date, but would...

I emailed Aqualink support and they finally replied. The SWG setting on the main screen requires Aqualink Revision Y which is the latest I believe. Since Jandy can't do simple firmware updates, that would mean replacing the physical board at I assume an absurdly high cost for a relatively simple...

Just turning mine like your are doing adjusts the level. If you push the float down you should just water flowing. There is a C shape piece at the top that controls the actual switch. Have your verified the source to your auto fill hasn't been turned off?

Picture from a thread with the same question recently.

The speedstir is rectangular, but slightly smaller. It fits without modifying the case.

I have the Alpha IQ+, which is basically the same robot. I also see condensation in the canister light window so maybe it is normal. The canister full symbol does come on with only some debris inside. The robot doesn't actually stop cleaning when that lights up though so I mostly ignore it and...

Did the speedstir change in size at some point? I have a #6100 purchased last year that fits fine.

Are you sure it was a Centerpoint line and not a separate line going to a gas grill, fire pit, etc? The former should have definitely been marked, the latter may or may not have been possible to mark. I had to have both moved this past summer and whoever put the gas grill in didn't put a tracer...

Pictures are representative of the measurements. There was more variation between bottles than I expected. 1oz: diameter - 28.7-29.6mm height - 84.4-85.5mm height to bottom of cap - 57-58mm 2oz: diameter - 38-38.7mm height - 106.8mm height cya cap - 93.2mm height bottom of cap - 78-79mm DPD...