Search results

Amazing. On MOBILETOUCH I checked menu/setup/advanced/circuit functions/low speed and it was set to "master cleaner" not "master pool". I corrected that and all is well. Thank you. I don't know how that happened as it worked fine until a couple of weeks ago. I appreciate the help!

On the remote (with system in auto) I have Low Speed selected to run the pump which is assigned for the main screen config; same config for several years. I'm not sure how I would run with a circuit feature or aux, but it does seem like something is preventing water temp from showing. thanks.

Good to know. Thanks.

I updated my signature - hope I've got it all this time. I called Pentair and they had no suggestions as there is little that can go wrong with installing a temperature sensor and as long as the pump is running it should be working. For additional information, when I disconnect the water temp...

Good point about how important the water temp is - more inconvenient just to not know the temp, including running the heater later to extend the season.

I updated my signature. Moving the water temperature probe to the air temp connections provided a reading, so I won't replace the probe again. The only display is on the PH4MOBILETOUCH remote. At this point I'm thinking it is the RF controller, although I guess it could be the main circuit...

I'll try this when I'm back in town.

Thanks for the response. No data there unfortunately. Just blank. All other data shows up, such as air temp.

The reading for the water temp (the one in the pipe between pump and filter) disappeared on my Mobletouch2. I ordered a replacement sensor. That didn't help. The replacement is simple - can't see that I did anything wrong. The casing on the probe on the old sensor was cracked in a few places...

mknauss, thank you for the help. Looks like it is the circuit board. My measurements showed 266 VAC going into the transformer and 31.7 VAC going into the circuit board. The voltage out (red and black) is only 27.8 VDC . Based on that, I'll try a new circuit board first.

The lights on my IC40 are out. There doesn't seem to be a fuse anywhere, although it is wired through the cb. There is a green light on the circuit board. Given that the unit is almost 7 years old (pool is open about 6 months out of the year) I know the most likely answer is that it needs...

Progress with concrete collar

Joel, Thank you for the comments about your experience. It seems there is not much negative to going with the robot cleaner then, except of course for the cost.

I'm trying to decide whether to go with a robot pool cleaner in my pool, under construction. Couple of questions: has anyone used a robot pool cleaner while a pool cover is closed, perhaps going through the skimmer for the cord? Also, I understand the Dolphin M5 is discontinued and there is...

Some progress, with a bit of rain in between; prepping for the concrete collar around the pool. The items on the far side of the pool are piers and plumbing for a water feature wall. Ready for the concrete pad for equipment in the back.

Thank you for the links pooldv.

Just looked at the photos from your pool. That is very nice - plus a pool house!

Installation is finally beginning after rainy weather delays this summer. The fiberglass pool is now in the ground and is in the process of being filled and leveled, with initial plumbing. I had a gunite pool a few years ago in Houston and maintained it with the methods used on this forum...