Recent content by wahoo98

Thanks for the suggestions. we ended up folding it over itself in sections and dried the bottom side as we folded it before releasing additional springs. Hopefully we got it dry enough! It was windy so that helped too. Luckily it was mainly condensation underneath.

Our pool was built last year and this the first year we are opening it. Anyone have a tricks in how to get a solid safety cover to dry out before putting it away so it doesn’t mildew? We don’t have a lot of concrete and we just had sod done so putting it on the grass ain’t happening! I have...

Curious if you have come across this unit yet. I have a new build and have one installed. I have questions and no one has been able to answer them. I have a call in with Hayward and am awaiting a tech to get back to me.

Thank you so much for all of your help! I am wondering if the electrician didn’t wire something correctly. But I will call Hayward tomorrow and confirm that the S3 should run the pump. I can also ask about how to know when chlorination is in on vs off. I am also wondering if should do a firmware...

Note we don’t have the Omni automation. I don’t think that makes a difference but thought I would mention it.

Hmmm. Well I wonder why it is not recognizing it when I do the set up? I have tried twice both times with VSP running at 1750 and 2000 rpm. I would assume that is enough flow for it to be “seen.”

SP2670020VSP

Hayward 1.65 TPH VS

Thanks. I will talk to PB ASAP. Here is a pic of our set up. Can’t see the pump because it is behind the filter but it has a connection going to the S3 and both VSP and S3 are independently connected to the timer.

Thanks. I will talk to PB ASAP.

Idk. It is a question we have for the PB. The pump appears to be wired to the S3 control box and both are independently wired to a timer. When I configured the S3 it didn’t “find a pump”. I want to run my VSP 24 hours so I removed the stop “pin” from the timer. I specifically requested a Hayward...

Thank your replying! Regarding the VSP, it is not controlled by the SWG. But I think I figured out since the SWG is driven by the flow switch, it should turn its self off, correct?

Anyone familiar with the Hayward Aquarite S3? We have an inground pool And that is the SWG that was installed. I am trying to dial in the percentage setting to optimize performance but also not prematurely use up the turbo cell. The cell installed is a T-340. I can’t figure out from the display...