Hi - I have a raspberry pi running Nodejs-poolcontroller & dashpanel. So far it's been fantastic!
Recently for some reason I'm getting this error in my terminal ssh session that constantly spams the logs:
`error: Error triggering nixie schedules Cannot read properties of null (reading...
Howdy! I have the old school Easy Touch automation (converted from Compool) inside of a metal control panel box.
I don’t want to waste $500 on the terrible Pentair wifi/app, and instead I want to try running this amazing Nodejs-pool controller project I just learned about on a Raspberry Pi...
Howdy! I have an Easytouch panel without the app so the interface is challenging. I have a Pentair Mastertemp Heater hooked up to the control panel.
Right now, I have a daily schedule where the pool pump runs 10 hours over night without the pump.
I have a new situation where I need the pool...
According to the manual (which is not totally clear!) I think I only need the two data wires connected and not the power wires. So I’m going to try that first.
I assume it’s okay to have the VS Pump COM wires share the input terminals with the Intellichlor COM wires??
Nope! That’s the culprit! Thank you! How do I tap into the coms signal from the power center, do you know?
I already have a VS pump plugged into the com port on the easy touch. So based on what I’m reading, I can just splice in the 2 intellichlor COM’s wires in there as well?
Howdy y’all-
I have Easy Touch with IC40 Intellichlor.
It’s my understanding that the SWG will automatically reduce its chlorine output when in spa mode. But I’m not seeing that on the IC40 control panel. It stays the same whether it’s in pool or spa mode. I would expect to see the output LEDs...